nomagic

no, it is not magic !

User Tools

Site Tools


arm:cortex_m0p

This is an old revision of the document!


ARM Cortex-M 0+

Memory Map

start address end address used for comment
0x00 00 00 00 0x1f ff ff ff Code
0x20 00 00 00 0x3f ff ff ff SRAM
0x40 00 00 00 0x5f ff ff ff Peripheral
0x60 00 00 00 0x7f ff ff ff RAM
0x80 00 00 00 0x9f ff ff ff RAM
0xa0 00 00 00 0xbf ff ff ff Device
0xc0 00 00 00 0xdf ff ff ff Device
0xe0 00 00 00 0xff ff ff ff System
0xe0 00 00 00 0xe0 0f ff ff PPB Private Peripheral Bus
0xE0 00 E0 08 0xE0 00 E0 0F System Control Block
0xE0 00 E0 10 0xE0 00 E0 1F SysTick optional
0xE0 00 E0 10 SYST_CSR SysTick Control and Status Register
0xE0 00 E0 14 SYST_RVR SysTick Reload Value Register
0xE0 00 E0 18 SYST_CVR SysTick Current Value Register
0xE0 00 E0 1C SYST_CALIB SysTick Calibration Value Register
0xE0 00 E1 00 0xE0 00 E4 EF Nested Vectored Interrupt Controller
0xE0 00 E1 00 NVIC_ISER Interrupt Set-Enable Register
0xE0 00 E1 80 NVIC_ICER Interrupt Clear-Enable Register
0xE0 00 E2 00 NVIC_ISPR Interrupt Set-Pending Register
0xE0 00 E2 80 NVIC_ICPR Interrupt Clear-Pending Register
0xE0 00 E4 00 0xE0 00 E4 EF NVIC_IPRO0-7 Interrupt Priority Registers
0xE0 00 ED 00 0xE0 00 ED 3F System Conrol Block
0xE0 00 ED 00 CPUID
0xE0 00 ED 04 ICSR Interrupt Control and State Register
0xE0 00 ED 08 VTOR optional
0xE0 00 ED 0C AIRCR Application Interrupt and Reset Control Register
0xE0 00 ED 10 SCR System Control Register
0xE0 00 ED 14 CCR Configuration and Control Register
0xE0 00 ED 1C SHPR2 System Handler Priority Register 2
0xE0 00 ED 20 SHPR3 System Handler Priority Register 3
0xE0 00 ED 90 0xE0 00 ED b8 Memory Protection Unit optional
0xE0 00 ED 90 MPU_TYPE
0xE0 00 ED 94 MPU_CTRL MPU Control Register
0xE0 00 ED 98 MPU_RNR MPU Region Number Register
0xE0 00 ED 9C MPU_RBAR MPU Region Base Address Register
0xE0 00 ED A0 MPU_RASR MPU Region Attribute and Size Register
0xE0 00 EF 00 0xE0 00 EF 03 Nested Vectored Interrupt Controller
0xe0 10 00 00 0xff ff ff ff Vendor_SYS
arm/cortex_m0p.1701907112.txt.gz · Last modified: 2023/12/07 00:58 by lars